How phoebey05/arduino-obstacle-course works
This project is an Arduino-based obstacle course project geared toward beginners who want to experiment with input/output devices on an Arduino UNO. The core functionality centers on reading inputs (from a dual-axis joystick and potentiometer) and displaying information on a 16x2 LCD. Additionally, the Room.cpp and Room.h files suggest that some portion of the project’s logic—perhaps related to the “room” or level configuration in the obstacle course—is encapsulated in a dedicated module.
Main Components
• Hardware Components:
• Arduino UNO R3 (the central processing unit where your software runs)
• Dual-Axis XY Joystick (input component)
• 16x2 LCD Display (output component)
• Potentiometer (input or config control)
• 220ohm Resistor (circuit protection/current limiting)
• Wiring (Male to Female, Male to Male jumper wires for connections)
• Software Components:
• obstaclecourse.ino – this is the main Arduino sketch that handles initialization, the main loop, and overall control flow.
• Room.cpp and Room.h – a module likely responsible for managing the "room" or environmental aspects of the obstacle course. It could contain functions to set up challenges or represent a level.
• .gitignore and README.md are documentation and project management files.
Out Relationships and Interactions
• The Arduino UNO is at the center of the architecture.
• Joystick → Arduino (for user input)
• Potentiometer → Arduino (for input or configuration)
• Arduino → LCD Display (for visual output)
• Within the software layer:
• Optionally, include a small annotation indicating that the Room module abstracts part of the game logic or obstacle course configuration.
Architectural Patterns & Technologies
• Hardware Abstraction Layer: The code in obstaclecourse.ino that directly interacts with hardware (reading sensor values, sending commands to the LCD).
• Application Logic/Room Module: All obstacle course logic abstracted into Room.cpp/h.
a. Start by drawing the central Arduino UNO block.
b. Around it, place smaller blocks for each connected hardware device (Joystick, LCD, Potentiometer, etc.) with connecting lines showing their interfaces (digital/analog pins).
c. Inside or connected to the Arduino block, detail the main software elements:
• Obstaclecourse.ino acting as the main program.
• The Room module as a separate block connected to obstaclecourse.ino, representing a logical abstraction used in the application.
d. Typical data/control flows (e.g., “Joystick Input”, “LCD Output”, “Command to Room Module”).