How aromring/frequencyanddutymeter works
Main components
• Hardware:
• The ItsyBitsy M0 Express board with its Atmel SAMD21 microcontroller.
• The input signal source – a 3.3 V square wave.
• (Optional) Any additional hardware such as indicators (LEDs), communication interfaces (for serial output) or other IO peripherals.
• Firmware:
• The FrequencyAndDuty.ino sketch containing the setup, main loop, and timing logic.
• Functions or modules within the sketch responsible for measuring pulse width and period (by counting the 48 MHz clock cycles).
• Data processing components that compute the frequency and duty cycle based on measured timing values.
Relationships and interactions
• The square wave signal is fed into a designated input of the microcontroller.
• The microcontroller’s timer/counter hardware (driven by the 48 MHz clock) is used in the firmware to measure the period and pulse width.
• The firmware then calculates the frequency and duty cycle from these measurements.
• The results may be output via serial communication (or other forms as indicated in the .ino file’s internal comments) to a debugging terminal, display, or logging interface.
Important architectural patterns and design principles
• Although the code is contained in a single .ino file due to the simplicity of most embedded firmware projects, there is a clear separation between hardware interfacing and signal processing functions.
• The design should emphasize real-time processing—capturing precise clock cycle counts to compute the metrics.
Relevant technologies
• Hardware: Atmel SAMD21 microcontroller, ItsyBitsy M0 Express board.
• Software: Arduino programming environment and libraries.
• Clock/timing mechanisms provided by the microcontroller’s hardware (48 MHz system clock).