How zeelladani/digital_clock works
Project Type and Purpose
• This is an embedded electronics project: a standalone digital clock built on an Arduino board.
• The purpose is to read the current time from a DS1307 RTC module, display it on an OLED screen, and optionally trigger an alarm.
File Structure Analysis
• Top-level files:
• PROJECT_CLOCK_with_alarm.ino / PROJECT_CLOCK_with_alarm_UPDATED.ino – two versions of the Arduino sketch
• README.md – wiring instructions and library setup
• LICENSE / .gitignore – supporting files
• No separate “src” or “lib” directories because the Arduino IDE expects a single .ino file and associated libraries are installed via the IDE.
Key Components (to represent
a. Arduino Uno (or compatible) microcontroller
b. DS1307 Real-Time Clock (RTC) module
c. 128×64 OLED display (SSD1306 driver)
d. Power source (USB or 5 V adapter)
e. (Optional) Buzzer or speaker for alarm output
f. Physical pushbuttons (if used for setting time or alarm)
g. I2C bus (SDA/SCL lines)
Relationships and Data Flows
• Power rail (5 V and GND) fans out to Arduino, RTC, OLED, buzzer, buttons.
• I2C bus:
• Arduino A4 (SDA) ↔ RTC SDA & OLED SDA
• Arduino A5 (SCL) ↔ RTC SCL & OLED SCL
• Control flow:
• On startup, Arduino initializes I2C, RTClib, SSD1306.
• Arduino polls RTC for current time.
• Arduino formats time and sends display commands over SPI/I2C to OLED.
• If alarm time reached, Arduino drives buzzer pin HIGH/LOW.
• (If buttons present) Arduino reads digital inputs to set time/alarm.
Architectural Patterns and Design Principles
• Layering:
• Hardware layer (power, bus, modules)
• Firmware layer (Arduino sketch: setup() + loop())
• Peripheral libraries (RTClib, Adafruit SSD1306)
• Separation of concerns: timekeeping (RTC), display logic, alarm logic, user input
Final Checklist
• Power rails (5 V/GND) drawn consistently
• Callouts for firmware layers or libraries (optional small text)