How thedavinder01/secure-radio-frequency-monitoring-system works
This is ESP32 firmware for a secure RF monitoring device. Its principal workflow is fingerprint-gated access, followed by periodic Wi-Fi/BLE monitoring and LoRa reception, with status shown on the OLED and events logged to SD; authenticated users can transmit over LoRa or NRF24. The README describes the monitoring and alerting goal, but the excerpt does not establish automatic anomaly detection or alert rules. The single source file combines orchestration and device features, so relationships are shown only where the excerpt supports them.
Main entry points: RF .c Firmware Loop
Components 19
Access and Control
- Firmware Loop
RF .c - Fingerprint Access
RF .c
Spectrum Monitoring
- Wi-Fi Scan
RF .c - BLE Monitor
RF .c
Radio Communication
- LoRa Receive
RF .c - LoRa Transmit
RF .c - NRF24 Transmit
RF .c
Device Interfaces
- OLED Status
RF .c - SD Event Log
RF .c - Clock
RF .c
Other components
- Operator
- OLED
- SD Card
- RTC
- Fingerprint Sensor
- Wi-Fi Environment
- BLE Environment
- LoRa Peer
- NRF24 Peer
Connections 19
- Operator → Firmware Loop: operates
README.md - Firmware Loop → Fingerprint Access: checks access
RF .c - Fingerprint Access → Fingerprint Sensor: reads prints
RF .c - Firmware Loop → Wi-Fi Scan: runs scans
RF .c - Wi-Fi Scan → Wi-Fi Environment: scans networks
RF .c - Firmware Loop → BLE Monitor: runs monitor
RF .c - BLE Monitor → BLE Environment: monitors
RF .c - Firmware Loop → LoRa Receive: checks packets
RF .c - LoRa Receive → LoRa Peer: receives packets
RF .c - Firmware Loop → LoRa Transmit: invokes send
RF .c - LoRa Transmit → LoRa Peer: sends packets
RF .c - Firmware Loop → NRF24 Transmit: invokes send
RF .c - NRF24 Transmit → NRF24 Peer: writes radio
RF .c - Firmware Loop → OLED Status: updates status
RF .c - OLED Status → OLED: renders
RF .c - Firmware Loop → SD Event Log: logs events
RF .c - SD Event Log → SD Card: writes records
RF .c - Firmware Loop → Clock: reads time
RF .c - Clock → RTC: gets clock
RF .c