How parthib007/ev_modelling_btms works
Project type and purpose
• This is a high-fidelity simulation project in MATLAB/Simulink/Simscape that models a pure electric vehicle (EV) drivetrain coupled with a liquid-based Battery Thermal Management System (BTMS).
• Its two main goals are:
• Simulate vehicle longitudinal dynamics under a standard drive cycle (FTP75) via a PI-based driver and power electronics
• Maintain battery temperature (20–40 °C) using an intelligent multi-path liquid cooling/heating loop
File structure
• Top-level files:
• ElectricVehicleThermalManagement.m – main simulation script or model loader
• ElectricVehicleThermalManagementParameters.m – parameter definitions (battery, control gains, thermal properties)
• ElectricVehicleThermalManagementPlot1Power.m – post-processing/plotting of power and efficiency results
• ElectricVehicleThermalManagementScenario.m – scenario setup (drive cycle selection, environmental conditions)
• README.md – project overview, architecture, and usage instructions
• No separate “src” or “lib” folders because the core logic lives in MATLAB scripts and Simulink models (referenced inside the .m files).
README for additional insights
Driver → Power Control Unit (PCU) → Motor → Vehicle dynamics
Battery (SOC & heat generation) ↔ Cooling Plate → Coolant Loop → 4-Way Valve → {Radiator, Heater, Chiller} → Loop
• It specifies technologies: MATLAB R2023b, Simulink, Simscape & Simscape Fluids
Detail without over-complicating
• Every module in the MATLAB file tree and the Simulink/Simscape blocks it references
• Parameter injection points (from ElectricVehicleThermalManagementParameters.m)
• Scenario-driven entry point (ElectricVehicleThermalManagementScenario.m) and the plotting script