How mspiceland/usdx-pebblehf works
Pebble HF is an experimental, single-band 20-meter QRP transceiver. Its principal workflow is operator input and audio/key signals processed by firmware into radio transmission, with received signals filtered and presented as audio. The README describes the firmware’s DSP, operating controls, and radio capabilities; the sampled flashing utility separately programs boards through avrdude. The firmware source is listed in the tree but was not excerpted, so internal firmware relationships are shown only where the README documents them.
Main entry points: usdx.ino Radio firmware · flash_pebble.py Flash utility
Components 11
Radio operation
- Radio controls
usdx.ino - Radio firmware
usdx.ino - VFO and RIT
usdx.ino - CW keyer
usdx.ino
Signal processing
- DSP transmitter
usdx.ino - DSP receiver
usdx.ino - RF transceiver
Board programming
- Board programmer
- Flash utility
utils/flash_pebble.py - avrdude
Other components
- Radio operator
Connections 11
- Radio operator → Radio controls: operates
README.md - Radio controls → Radio firmware: sets operation
README.md - Radio firmware → VFO and RIT: supports tuning
README.md - Radio firmware → CW keyer: supports keying
README.md - Radio firmware → DSP transmitter: runs transmit DSP
README.md - Radio firmware → DSP receiver: runs receive DSP
README.md - DSP transmitter → RF transceiver: drives transmission
README.md - RF transceiver → DSP receiver: provides signals
README.md - Board programmer → Flash utility: runs utility
utils/flash_pebble.py - Flash utility → avrdude: invokes
utils/flash_pebble.py - Flash utility → RF transceiver: programs firmware