How maheswar-eltro/arduino-robot works
This is an ESP32/Arduino two-wheel robot project. Its main workflow is keyboard input translated into left/right motor commands, sent either over serial or Wi-Fi, then handled by embedded control and the motor driver. The README documents basic movement, wireless control, and the hardware stages; sampled Python confirms the host-side command loops. Firmware internals were not sampled, so documented links are cited to the README rather than inferred from filenames.
Main entry points: keyboard-control.py Serial WASD sender · remote_control.py UDP WASD sender · keyboard-control.ino Keyboard firmware · remote_control.ino ESP32 remote firmware
Components 8
Host controls
- Serial WASD sender
src/control/keyboard-control/keyboard-control.py - UDP WASD sender
src/control/remote-control/remote_control/remote_control.py
Embedded control
- Basic movement
src/basic-movement/basic-movement.ino - Keyboard firmware
src/control/keyboard-control/keyboard-control.ino - ESP32 remote firmware
src/control/remote-control/remote_control/remote_control.ino
Robot hardware
- TB6612FNG driver
- Drive motors
Other components
- Keyboard input
Connections 8
- Keyboard input → Serial WASD sender: provides keys
src/control/keyboard-control/keyboard-control.py - Serial WASD sender → Keyboard firmware: sends serial commands
- Keyboard input → UDP WASD sender: provides keys
src/control/remote-control/remote_control/remote_control.py - UDP WASD sender → ESP32 remote firmware: sends Wi-Fi commands
README.md - Basic movement → TB6612FNG driver: controls motors
- Keyboard firmware → TB6612FNG driver: controls motors
README.md - ESP32 remote firmware → TB6612FNG driver: controls motors
README.md - TB6612FNG driver → Drive motors: drives
README.md