How kwwsoft/irstation_448 works
This repository contains PIC18F448 firmware and a Windows PC application for an infrared soldering station. The apparent user workflow is operating the station through the PC interface, with automatic, manual, preheat, and historical-data screens, alongside embedded control and sensor-reading code. The entry point explicitly creates the application forms. Firmware internals and PC-to-station communication are not shown in the excerpts or README, so their connections are omitted; the hardware layout files are represented without inferred wiring.
Main entry points: irstation.cpp PC entry point · Unit2.cpp Station interface · MenuAvtomat3Form.cpp Automatic mode · MenuManualForm.cpp Manual screen
Components 17
PC application
- PC entry point
soft_pc/irstation.cpp - Station interface
soft_pc/Unit2.cpp - Automatic mode
soft_pc/MenuAvtomat3Form.cpp - Manual screen
soft_pc/MenuManualForm.cpp - Preheat screen
soft_pc/MenuPreHeatForm.cpp - Preheat PID
soft_pc/GyverPIDPreHeatForm.h - Historical data
soft_pc/MenuOldDatalForm.cpp - About screen
soft_pc/about.cpp
Station firmware
- PIC controller
soft/irs448.c - Hardware initialization
soft/global.c - Resistor sensing
soft/adc_resistor.c - Manual control
soft/manual.c - Firmware variables
soft/variables.c
Hardware design
- Main board layout
hard/main.lay - Regulator design
hard/reguljator_main.spl7 - Power layout
hard/power.lay
Other components
- Operator
Connections 7
- Operator → PC entry point: starts
- PC entry point → Station interface: creates form
soft_pc/irstation.cpp - PC entry point → Automatic mode: creates form
soft_pc/irstation.cpp - PC entry point → Manual screen: creates form
soft_pc/irstation.cpp - PC entry point → Preheat screen: creates form
soft_pc/irstation.cpp - PC entry point → Historical data: creates form
soft_pc/irstation.cpp - PC entry point → About screen: creates form
soft_pc/irstation.cpp