How gniezen/openpump works
Openpump is an open-source syringe-pump hardware platform: the user configures and builds the mechanical and electronic device, installs Arduino firmware, and uses the pump to dispense fluid over a set period. The repository contains CAD models, enclosure designs, circuit design files, and firmware assets. The firmware sketch and most design files were not excerpted, so implementation-level connections are limited; the firmware asset header is shown, but its runtime use is not established by the excerpt.
Main entry points: firmware.ino Arduino Firmware · linear_actuator_v0.scad Actuator CAD · pump-shield Pump Shield Circuit · mechanical Printed Parts
Components 10
Pump Mechanics
- Actuator CAD
mechanical/linear_actuator_v0.scad - Printed Parts
mechanical
Electronics and Firmware
- Arduino Firmware
firmware/firmware.ino - UI Assets
firmware/default_assets.h - Pump Shield Circuit
schematics/pump-shield
Enclosure Design
- Enclosure CAD
enclosure/scadModel
Other components
- Pump Builder
- Arduino Mega
- Stepper Driver
- Syringe Pump
Connections 8
- Pump Builder → Actuator CAD: customizes parts
README.md - Actuator CAD → Printed Parts: renders parts
README.md - Pump Builder → Arduino Firmware: installs firmware
README.md - Pump Builder → Pump Shield Circuit: builds electronics
README.md - Arduino Firmware → Arduino Mega: runs on
README.md - Arduino Firmware → Syringe Pump: controls dispensing
- Pump Shield Circuit → Arduino Mega: connects components
README.md - Pump Builder → Enclosure CAD: customizes enclosure