How eua/esp32_logicanalyzer works
This is ESP32 firmware for a SUMP-compatible 16-bit logic analyzer. The documented workflow is to connect PulseView over serial, configure the board and pins, capture digital input with I2S DMA, and return samples using the analyzer protocol; 8/16-bit modes and RLE compression are supported. The header excerpt shows DMA state and sample-processing routines, but does not show the runtime calls that connect them. Relationships below therefore rely on README documentation where possible; unsampled sketch wiring is not inferred.
Main entry points: ESP32_LogicAnalyzer_I2S_DMA.ino I2S DMA capture · ESP32_LogicAnalyzer.ino SUMP serial interface · ESP32_LogicAnalyzer.h Board configuration
Components 6
Firmware runtime
- Arduino sketch
ESP32_LogicAnalyzer.ino - Board configuration
ESP32_LogicAnalyzer.h
Signal capture
- I2S DMA capture
ESP32_LogicAnalyzer_I2S_DMA.ino - Sample processing
ESP32_LogicAnalyzer.h
Host protocol
- SUMP serial interface
ESP32_LogicAnalyzer.ino
Other components
- PulseView
Connections 4
- PulseView → SUMP serial interface: sends commands
README.md - Board configuration → I2S DMA capture: configures pins
README.md - I2S DMA capture → Sample processing: captures samples
README.md - SUMP serial interface → PulseView: returns samples
README.md