How bishnu-subedi/xbee-based-serial-communication-using-arduino- works
Project type and purpose
• This is an embedded-systems communication project using Arduino and Digi XBee modules.
• It consists of two C programs: Transmission.c (sends data) and Reception.c (receives data).
• The goal is to demonstrate simple UART-based serial communication over wireless (XBee) links.
Main components
a. Hardware nodes
• Arduino Uno #1 running Transmission.c
• XBee radio module #1 (connected via UART to Arduino #1)
• Arduino Uno #2 running Reception.c
• XBee radio module #2 (connected via UART to Arduino #2)
• (Optional) A host PC or serial monitor connected via USB to either Arduino for debugging/logging
b. Communication channels
• UART link between each Arduino and its attached XBee module
• Wireless (RF) link between the two XBee modules
• USB link between Arduino and host PC (for logging or control)
Relationships and data flows
• On the transmitter side:
• Sensor or data source → Transmission.c on Arduino → UART TX → XBee module → RF → remote XBee
• On the receiver side:
• RF → XBee module → UART RX → Reception.c on Arduino → output (e.g., Serial Monitor/LED)
• If a PC is connected: Arduino ⇄ USB serial port ⇄ PC
Architectural patterns and design principles
• Separation of concerns:
• Firmware (Transmission.c / Reception.c) focuses on UART read/write and application-level logic
• XBee modules handle the wireless PHY/MAC transparently (AT mode or API mode)
• Clear layering:
• Hardware layer (Arduino MCU, XBee radio)
• Firmware layer (microcontroller code)
• (Optional) User interface layer (serial monitor on PC)
• Simple pipeline processing: read → package → transmit → receive → process